In an ill-advised bout of self-reliance, I took took off the belt-line chrome/rubber trim below the driver’s side rear window as I noticed a bit of the thin lower rubber seal was kinked. Got that straightened, but unfortunately couldn’t clip the trim back properly. It’s on, but it’s not sitting flush. I can get most of the rubber tight to the window at the top, but it's not quite right and the thin lower rubber is sitting proud of the bodywork. Not sure what I'm doing wrong, but worried I'm going to bend or break something if I force it. I know it’s probably shooty-in for normal people, but it’s just not behaving itself.


Tried online guides, but they're all Gen 1 or Gen 3 stuff! Any ideas? Ta.