Ken, it may be loud but I love the colour coded option!
Is the sweetie holder thingy easy to fit?
Ken, it may be loud but I love the colour coded option!
Is the sweetie holder thingy easy to fit?
Loud Dash....check this out , spot the volume control !!!!
http://community.webshots.com/photo/54420865/166594129ZGJPsD
http://community.webshots.com/photo/54420865/166594159DTxAFZ
For those of you who may wish to fit the 05 utility box I found this on Mini 2
http://www.jwardell.com/mini/utilbox.html
Hope it helps cause I think it will help me.
I found another article that said it is possible to fit the new box without going to the bother of removing the pillars etc. I'll try that first!quote:Originally posted by R7 ETH
For those of you who may wish to fit the 05 utility box I found this on Mini 2
http://www.jwardell.com/mini/utilbox.html
Hope it helps cause I think it will help me.
Yeah i thought that seemed a bit OTT, will try before removing the pillars also.
Advice from Paul Mullet:
Here is how he did it:
Removed single torx screw.
Took out current piece angling it through the gap behind the down tube.
Put new one in basically the same way, angled it through, being careful not to mark anything.
Clip into place.
Massaged the lip under the gearleaver section.
Replaced screw.
Put in rubber mat.
Took about 5 minutes.
sorry very childish of mequote:
Massaged the lip
Well, that is it fitted - bit of a struggle but got there. Just the job.
Well done !!! ordered mine last weekend but going to the Scottish mini weekend on Saturday so i wont be able to pick it up till next week :(
I got mine today