Printable View
The airbag light on my dash has been on ever since i unplugged the seat plug and put my new seats in.
What i want to know is, is there a way you can switch the airbag light off(not taking bulb out) so that the airbags work again, An without putting the original setas back in the car :frown:
cheers guys
it MIGHT need coded, just to let the car know there is not an airbag system there.
Are you saying you have put in seats that dont have airbags?
If so then you need to fit a small fuse to the harness to fool the car that there is an airbag there. I can't remember what size fuse you need but if you have a look on www.mini2.com you will find the answer and because you have already had the ignition on and activated the light it will need re-set, this can be done by most garages.
Good point John, i totally forgot about the resistor.
Quote:
Originally Posted by john
I have put a set of Sparco seats in :D So no airbags.
Had a little look on mini2 but couldn't find what i was looking for. So where about would you fit the fuse to make the car think theres an airbag( prob a silly Q).
Thanx again for all the help :thumbs up:
It goes onto the plug where the seat used to be pluged intoQuote:
Originally Posted by cooperchris
You need a 3.9 ohms resistor, BUT!!!!!!!!
Given that the light is already on and need programing anyway, I would just forget about the resistor and get the car programed to say it has no seat airbags, sadly this means going to your MINI dealer and will cost money.:yes nod:
thanx for all the help, once its on the road al pop down an speak to a friend at BMW.Quote:
Originally Posted by john
thanx again :thumbs up: